Skip to content
Answered 24/7(720) 964-0667
Hydronic and forced air heat

Furnace Repair in Denver, CO

When the furnace quits on a January night, we come out around the clock. We repair igniters, flame sensors, inducers, blowers and controls on gas furnaces of every major brand.

Typical range$169 to $786
Time on siteMost repairs take 1 to 2 hours
PhonesAnswered 24/7
HVAC technician testing a furnace control board with a meter in a basement mechanical room
Quick answer

Most furnace repair jobs we handle in Denver land between $169 and $786, depending on access, materials and timing. Most repairs take 1 to 2 hours. Call (720) 964-0667 any hour and a person answers.

When to call

Signs you need furnace repair

  • No heat or cool air from vents
  • Furnace short cycling
  • Loud bangs, squeals or rattles
  • A blinking code on the control board

Our plumbers carry the parts most furnace repair jobs need, which is why so many of these calls are finished on the first trip.

What we see in Denver homes

At a mile high, a furnace must be derated for altitude and vented correctly. Many no heat calls trace back to a pressure switch or venting problem made worse by snow or ice on the vent.

thermostat on a hallway wall set to heat on a snowy evening
Typical furnace repair cost$169 to $786
Time
Most repairs take 1 to 2 hours
Phones
Answered 24 hours a day
Quote
Given before any work starts

Ranges reflect recent Denver jobs and are a guide, not a quote. Your price is confirmed on site.

Our process

How we handle furnace repair

  1. Read the codes

    Control board codes and a full check point to the cause.

  2. Repair

    Igniters, sensors, pressure switches and blowers are on the truck.

  3. Safety check

    Heat exchanger, venting and gas pressure are checked.

  4. Test cycles

    We run full cycles to confirm the fix.

What changes the price

  • System type and age
  • Parts and controls needed
  • Access to the boiler or furnace
  • Any venting or gas pressure corrections

Before we arrive

Note any error codes, noises or rooms that are not heating, and clear the area around the equipment.

Questions

Furnace Repair FAQs

Why does my furnace shut off after a few minutes?

A dirty flame sensor, a blocked filter or a venting issue are the usual causes.

Should I check my high efficiency vent after snow?

Yes. Snow drifts can block PVC intake and exhaust pipes and shut the furnace down.

Can you do furnace repair the same day in Denver?

Yes, in most cases. Most repairs take 1 to 2 hours. Call early in the day and we will tell you honestly when a plumber can be at your door anywhere in Denver.

Related work

Often booked with furnace repair

Furnace Installation

A new furnace sized by a real load calculation heats the house evenly and quietly.

Furnace Installation

Heating Tune-Ups

A yearly tune up catches weak igniters, cracked vents and dirty burners before the first cold night.

Heating Tune-Ups

Gas Leak Detection & Repair

If you smell gas, leave the house and call the gas utility first.

Gas Leak Detection & Repair
Where we work

Furnace Repair across the Denver metro

We send plumbers from our downtown Denver office to neighborhoods, nearby cities and surrounding counties.

Need furnace repair today?

Call and a real person answers, day or night. We will tell you what it likely is and when we can be there.

(720) 964-0667
Call (720) 964-0667 · 24/7